GrowMax Water Pressure Pump Kit

Features of the pressure pump kit for reverse osmosis equipment

The pressure pump kit for reverse osmosis equipment is especially indicated for working with filters of 500 or 1000 liters of water per day. The objective of this kit is to increase the inlet pressure to the appropriate level so that the osmosis filter can offer more efficient performance.

How to get the most out of the pressure pump kit?

Many growers often install a reverse osmosis filter to obtain clean irrigation water, without mineral salts and other sediments. However, in many cases this filter does not meet all expectations, since it requires a minimum water pressure for its operation. If the pressure is insufficient, the flow of purified water is greatly reduced and water waste is maximum. Hence, a pressure pump is needed to take full advantage of the work of the reverse osmosis filter. The pressure pump kit is the perfect device to get the most out of water treatment, solving the problem of low pressure in the tap pipes. To make the most of this system, you can choose one of the two kit models available (500 or 1000 liters of water per day).

How to use the pressure pump kit for reverse osmosis equipment?

The pressure pump is installed between the osmosis filter intake and the supply pipe or tap. Once the pressure pump kit for reverse osmosis equipment is installed, you will see how the tap water comes out in a continuous stream.