Cooltube/Adjust-a-Wings Converter

How to use the conversion kit to join Cooltube and Adjust-a-Wings?

Accompanying the Adjust a Wings with a cooltube is essential to guarantee an adequate heat dissipation process and avoid overheating in the lighting system. Using a Cooltube allows the temperature to decrease by up to 3°C inside the grow room. However, this conversion kit is required to carry out the installation process. To install it and be able to use it properly you must be careful and follow the following steps .

1. Remove the plastic that protects both wings.
2. Place the nuts on the pieces that come with the kit.
3. Insert the rods into the holes that the cooltube has at each of its ends.
4. Observe where exactly on the wings you want to place the cooltube and insert the rods into the slot of the pieces that come with the kit and secure it with the corresponding washers and nuts.
5. Proceed to remove the turnbuckles and nuts from the Adjust-a-Wings and align the holes in the pieces with the holes in the reflector.
6. Lastly, secure the Cooltube to the reflector by placing the nuts through the holes where you placed the pieces.

You can buy the conversion kit together with the Cooltube reflector

If you still do not have a Cooltube, you can buy the one you like the most at a special price together with this kit, so that you can ensure that the heat generated by the bulbs is properly dissipated while the Adjust a Wings distributes it in the best way. the light produced by your halide bulbs.