Gavita Pro 600 SE Complete Set – HPS 600W Fixture with HortiStar HR96 Reflector

Complete set Gavita Pro 600 SE: HID luminaire 600 W Single Ended with ballast attached to the HortiStar HR96 reflector. It is a single-piece solution, ready to hang and plug in, with no separate ballast to place or wire up.

⚠️ Confirm the voltage before ordering

Gavita also manufactures a 400 V three-phase version of this unit. Plantasur states 220-230 V for reference, but the Hortitec supplier describes theirs as «600 W at 400 V». Before placing the order, consult us and we will confirm the exact voltage of the unit being supplied: a 400 V three-phase unit will not work in a Spanish single-phase domestic installation.

Non-dimmable ballast

This model includes a non-dimmable electronic ballast: it always operates at 600 W and is not compatible with Master Controller. If you need to adjust the power or centrally control the room, the indicated version is the Pro 600e SE.

HortiStar HR96 reflector

Aluminum reflector with 96 % reflectance, geometry designed for uniform distribution in table cultivation. E40 socket.

Technical data

• Type: complete Single Ended HID set
• Power: 600 W
• Socket: E40
• Reflector: HortiStar HR96, 96 % reflectance
• Ballast: electronic, non-dimmable
• Master Controller compatible: no
• Approximate PPF: ~1150-1190 µmol/s depending on the lamp installed
• Weight: 5.0 kg

The PPF comes from the official Gavita datasheet and depends on the lamp installed: the supplier does not publish it.

At GrowIndustry we only work with products of proven quality and trusted brands.

Each item goes through a check before shipping to ensure you receive it in perfect conditions and ready to use.

Your satisfaction is our priority.

1. Consúltanos y confirma la tensión de la unidad antes de pedirla.
2. Instala una lámpara HPS o MH de 600 W con casquillo E40.
3. Cuelga el conjunto centrado sobre el cultivo con soportes adecuados.
4. Deja 50-70 cm sobre la copa y ajusta con la mano segun el calor que notes.
5. Conéctalo a una toma de 230 V con puesta a tierra.
6. Programa el fotoperiodo con un temporizador externo: no admite dimado.