Pure Factory Wired Pure LED and P-LED – Power, Interconnection and 0-10V Signal Cables

The five cables of the Pure LED and P-LED system from Pure Factory. There are two different families and they are not compatible with each other: check which one your fixture needs.

Power cables

• Pure LED power supply: for fixtures in the Pure LED range (PRO, MAX, EXPERT, Q) and also for the Lazerlite Pro 720 W and 1080 W.
• P-LED V2.0 power supply · 2 m: for P-LED V2.0 bars, which are sold without a cable. Supports up to 5 bars of 42 W or 10 of 26 W on the same line.

Interconnection cable

P-LED V2.0 interconnection · 1 m: connects one P-LED V2.0 bar to the next to daisy-chain them.

0-10 V signal cables

The 5 m and 10 m ones carry the 0-10 V dimming signal from the controller to the fixture, or between fixtures in a chain. These are control cables, not power cables: without them the controller cannot regulate anything. Choose the length according to the actual route distance.

Technical data

• Pure LED power supply: Pure LED range and Lazerlite Pro 720/1080 W
• P-LED V2.0 power supply: 2 m, up to 5×42 W or 10×26 W
• P-LED V2.0 interconnection: 1 m
• 0-10 V signal: 5 m and 10 m

Weights are estimates.

At GrowIndustry we only work with products of proven quality and trusted brands.

Each item goes through a check before shipping to ensure you receive it in perfect conditions and ready to use.

Your satisfaction is our priority.

1. Identifica tu gama: Pure LED o barras P-LED V2.0.
2. Elige el cable de alimentación correspondiente a esa gama.
3. Añade el de interconexión de 1 m si vas a encadenar barras P-LED.
4. Si tienes controlador, mide la distancia y elige señal de 5 o 10 m.
5. Cablea con la instalación desconectada de la red.
6. Da tensión y comprueba que el controlador regula las luminarias.