Canna pH+ – pH Regulator to Increase the pH of Irrigation Water in Hydroponic and Soil Crops

Canna Ph+ Characteristics

Canna's pH+ is a solution to massify or raise the pH of the water of irrigation that you use in your crop. You can use it in any type of crop, so it doesn't matter if you grow in hydroponics, coconut or soil, you will always have the best results guaranteed. 

Composition and benefits of Ph+ from Canna

PH+ from Canna contains:

• potassium carbonate
• 12% caustic potash
• 28.2% potassium oxide

These elements have the acidity necessary to raise the pH of the nutrient solution without altering its composition. That is why you will enjoy different benefits. How improve nutrient assimilation, since an adequate pH level accelerates the assimilation of nutrients and avoids blockages in the roots, which cause you to waste time and money, since they prevent the nutrients provided from being absorbed by the plant. 

Dosage and how to use Ph+ from Canna

Unlike other products such as fertilizers and additives, there is no precise dose to apply pH+, since the necessary amount varies based on acidity level that throws the meter and the growing medium. However, a few milliliters are usually enough to balance the irrigation solution. To use it you will have to measure pH and then add the drops until obtaining the desired parameter. In aqueous media it should remain between 5.5 and 5.8 during growth and rise between 5.8 and 6.2 in the flowering phase; while in coconut the margin is between 5.5 and 6.5. In soil crops it is more complicated, since you must measure the pH of the substrate and based on that adjust the irrigation water.

At GrowIndustry we only work with products of proven quality and trusted brands.

Each item goes through a check before shipping to ensure you receive it in perfect conditions and ready to use.

Your satisfaction is our priority.

1. Prepara el agua de riego y añade todos los nutrientes y aditivos primero.
2. Mide el pH de la solución preparada.
3. Si el pH está bajo, añade pH+ de Canna gota a gota mezclando tras cada adición.
4. Vuelve a medir hasta alcanzar el pH objetivo para tu sustrato.
5. Para tierra: pH 5,8-6,2. Para coco e hidro: pH 5,5-5,8.
6. Nunca añadas pH+ directamente sobre el concentrado de nutrientes sin diluir.