VDL Climatron Pro EC Electrode – Replacement Electrode 0-5 mS/cm for pH/EC Monitor

VDL Climatron Pro EC Electrode – 0–5 mS/cm Replacement Electrode for pH/EC Monitor

Replacement electrical conductivity electrode for the VDL Climatron Pro pH/EC Monitor (ref. 600493), with a measurement range of 0 to 5 mS/cm and an accuracy of ±5% of the reading. It is the same electrode that comes standard with the monitor, so it replaces the original part without any modifications. Replacing it when EC readings begin to drift restores the equipment's reliability without the need to replace the monitor.

Key Features

• 0 to 5 mS/cm range: covers the conductivity values typical of nutrient solutions used in cultivation.
• Accuracy of ±5% of the reading: provides a stable margin for making informed fertilizer dosing decisions.
• Original system electrode: the same electrode that comes standard with the Climatron Pro pH/EC Monitor.
• Direct replacement: replaces the original without special tools or modifications to the equipment.
• Cost-effective maintenance: restore accurate EC measurements by replacing only the electrode.

Technical Specifications

• Parameter: electrical conductivity (EC)
• Measurement range: 0–5 mS/cm
• Accuracy: ±5% of the reading
• Use: replacement EC electrode for the VDL Climatron Pro pH/EC Monitor
• Weight: 0.205 kg
• Reference: 600495

What's Included

• 1 × replacement EC electrode

Compatibility

This electrode is the replacement for the VDL Climatron Pro pH/EC Monitor (ref. 600493), which already includes it as standard: if the monitor is new, you do not need to purchase it. Purchase it when the original electrode begins to provide inaccurate or unstable EC readings. The pH/EC monitor is the accessory that displays the EC and pH values of the nutrient solution on the screen of the VDL Climatron Pro controller (ref. 600492). For pH measurement, the corresponding replacement is the pH probe (ref. 600494).

At GrowIndustry we only work with proven quality products and trusted brands.

Every item goes through a check before shipping to make sure it arrives in perfect condition and ready to use.

Your satisfaction is our priority.

1. Unplug the VDL Climatron Pro pH/EC Monitor from the power supply before replacing the electrode.
2. Remove the old EC electrode from the reservoir and disconnect its connector from the monitor.
3. Rinse the new electrode with clean water and check that the measuring cell is free of residue.
4. Connect the new electrode to the monitor and plug the device back in.
5. Calibrate the EC following the monitor menu and select your preferred unit on the Climatron Pro (EC, CF, TDS x500 or PPM x700).
6. Submerge the electrode in the nutrient solution reservoir, check the reading, and rinse it with clean water after each solution change.